Looking On The Bright Side of Services

      Comments Off on Looking On The Bright Side of Services

How To Install a Garage Door The first step to installing a new garage door is removing the old door, using the instructions provided by the door manufacturer, carefully remove the old door, this consists mainly carefully unlatching the door from the pulley system, then the panels of the door are taken apart and then unscrewing the tracks, care should be taken so that the panels do not fall on you by making sure only one panel is removed at a time measurement of the areas where the door is to be installed first takes place, these areas include the door opening height and width, the headroom and the back room, after measurement, to both sides of the opening, stops are attached, they should flush with the inside edge of the door jamb, the bottom piece of the new door is then laid out using sawhorses, additionally weather stripping may be attached, hinges attached and handles lifted to piece setting it properly using a level, the bottom piece is inserted into the door frame, the tap nails then partway into each jamb, to secure them in place the nails are bent slightly then using manufacturer’s instructions, the vertical, horizontal and curved pieces of the track are then assembled and then set aside The second panel is then installed on top of the first one, nails are then hammered into the side jambs so that they are well held in place, hinges are the next installed, then the process is repeated according to the number of panels that are necessary, however, it is a requirement that each of the pieces is anchored into the door jamb, this marks the completion of the fourth step undertaken when installing a garage door
Lessons Learned About Services
after securing all sections, rollers are then installed in the section that does support them after which they are placed in the assembled track, as one goes along the brackets of the tracks are secured, the rollers should not be pressed too tightly against the track to avoid friction which damages the door during usage
What Almost No One Knows About Repairs
after securing the vertical tracks against the jambs, the horizontal and curved pieces are installed next, previous measurements are used during installation of the horizontal pieces, the tracks should be straight and point 90 degrees away from the opening, springs are then assembled according to manufacturer’s instructions, in order to make the tracks level and parallel, the door is lifted to about half length, in order to attach springs to the pulley, the door is lifted up the remaining distance, that is how a new garage door is opened