Lessons Learned from Years with Sales

      Comments Off on Lessons Learned from Years with Sales

How to Use Plasma Cutters Safely and Effectively Plasma cutting is a precious tool for getting fast, neat cuts in steel, aluminum, or stainless. This is attainable with the use of plasma cutters that merge a high-pressure air or gas flow with an electric arc. The heat may go up to a temperature of up to 40,000 degrees Fahrenheit. The following are some things to keep in mind while you’re using a plasma cutter: Safety is Priority While plasma cutting is not as intense as welding, you have to proceed as though it is. Ensure you wear flame-retardant clothes and hair protection. Put on glasses #5 eye protection and work in a safe spot. Know your environment. Take note that the heat and light can be overpowering, and you need to ensure your safety.
What Research About Equipment Can Teach You
Consumables
What You Should Know About Sales This Year
In case you notice that your cuts are losing their sharpness, you may have to replace some or all of the parts that compose the cutting head. Usually, this could consist of a heat shield, contact tip, insulators, nozzle, and offset tool. It’s wise that you check the availability of the said consumables as you purchase your plasma cutter. Pick a new model with a simple process for ordering parts. The Importance of Moisture Plasma cutters need clean, dry air in order to function properly. Moisture is the main cause of parts turning bad. There are some things you can do to decelerate the effects of moisture, and control it to a bare minimum. Give 25 – 30 feet of line going from the air compressor to the moisture trap. The moisture trap is going to work better if the air can cool first. You can get an air drier that utilizes silica gel to attract moisture from the air. Have two in fact – they are inexpensive. These could be installed at the compressor and at the water trap to stretch the life of your consumables. The air driers themselves are going to be easier and cheaper to replace compared to the plasma cutter parts. Cutting Speed You have to cut at the correct speed. If you’re new to plasma cutting, it might take you a number of tries to dialed it in properly. Among the best signs is the direction of the sparks while you’re cutting. If you cut too quickly, the sparks move towards you. You should take it slow. The sparks and dross have to head towards the floor. The Angle Usually, you will be holding the plasma cutter at a 90-degree angle to whatever you are cutting. Reaching the end of a cut, pull the angle up a bit to make for a beautifully smooth end of cut. Dross on the underside of your cut can be addressed with a small file.